How do I know what size clock mechanism I need?
The post mounting hole of your clock dial (or mounting material) needs to have a large enough diameter to fit the shaft of the clock movement through it. The easiest and most accurate way to measure the shaft length on a clock movement is to use the depth gauge on a digital caliper.
Are clock mechanisms a standard size?
There are generally 4-6 basic sizes of movement available and your movement will generally fall into one of the sizes available between 9-31mm in length, if you movement is an odd measurement then the way round it is to simply go for the longer length shaft thats as close to your required measurement and put a spacer …
What size hand is a 24 clock?
In Figure 3 this clock is a 24″ clock and the designer chose 10″ Clock Hands – generally, you want your clock hands to sit somewhere between the inside and outside edge of your numbers or numerals. So a little less than half the diameter of your clock face is standard.
Are clock hands universal?
Lots of people think whatever clock hands they have will fit a new clock movement. This is not usually true. The mounting holes are not well standardized. So, if you already have the clock hands, you can just choose a similar length and style from us.
What is clock dial thickness?
Dial thickness is the measurement of the material that the shaft of the clock motor is going through. Example you have a piece of material which is 8mm thick you would simply choose a 10mm dial thickness size as the 6mm dial thickness would be to small and the 10mm is suitable for sizes up to 10mm.
How big should my clock be?
A wall clock should be between six inches and eighteen inches in width. Wall clocks come in three general sizes: small, medium, and large.
What is the long hand on a clock?
The large hand on a clock that points to the minutes. It goes once around the clock every 60 minutes (one hour). Example: in the clock on the left, the minute hand is just past the “4”, and if you count the little marks from “12” it shows that it is 22 minutes past the hour.
Which hand goes first on clock?
How are the clock hands mounted? As a first step, insert by pressing the hour hand on the h 12, until you reach the stop with the thread. Afterwards, always insert the minute hand on the h 12 until the stop is reached. Finally insert the second hand into the fulcrum of the shaft.