Pull the plastic guard from beneath the crown knob (located on the right edge of the watch), and push the crown knob into the watch to start your watch. You will see the second hand begin to advance. Pull the crown knob out to the middle position to set the day.
How do I set the day on my Timex watch?
Pull the crown on the side of the watch case all the way out. This will be position “C,” with position “A” having the crown pushed all the way in and position “B” being pulled out halfway. Turn the crown clockwise until the correct day appears on the small face displaying the day.
How do you set the Timex Indiglo watch?
Pull the knob out from the watch slowly until it clicks into the first position. Turn the knob to move the hour and minute hand to set the time. Move the knob clockwise to move the settings forward and counterclockwise to move them backwards. Pull the knob out further until it clicks into the second position.
How do I change the date on my Timex Indiglo wr30m?
Use the START/STOP button to advance the minutes. Pressing MODE again will allow you to adjust the month, date and day of the week. You may also press MODE to toggle between the 12-hour and 24-hour display. Press SET/INDIGLO when you are done.
How do I change the day on my watch?
Set the date by pulling the crown out to its first position for the vast majority of mechanical watches with a date function. Turn the crown gently to set the date. If your watch also has a day-of-the-week display, you can usually also set it via the crown in this position by turning it in the opposite direction.
How do I reset my Indiglo watch?
Press the “Start/Split” or “Stop/Reset” button your Indiglo. Hold it down long enough to stop all of the cycle alarms if they are going off. Look for the clock icon that shows up on your watch face to see if the alarm is disarmed.
How do you change the date on a rotary watch?
In order to set the day or date of your Rotary watch, the crown must be in position ‘A’. Rotating the crown clockwise in this position changes the day and anti-clockwise changes the date. In order to set the time, the crown must be in position ‘B’.
To set the time and date you would press both buttons at the same time and hold them down for 5–10 seconds. Part of the time display would then start flashing, indicating that you’re now in time -setting mode, and can release the buttons.
When should you not adjust the date on a watch?
You should not make adjustments – such as setting the date or day of the week – when the time on the watch reads between the hours of 9:00 pm and 3:00 am. Each movement has its own guidelines so this may vary a little, but avoiding setting anything a few hours either side of midnight should keep you out of trouble.