How do you change the time zone on a Hammacher Schlemmer clock?

How do I change the time zone on my projection clock?

While in Normal Time Mode, Press and Hold the SET button for two seconds to enter the time, date, and Time Zone settings mode. The Hour will flash. Press the ADJUST button to change. Press and hold the ADJUST button to change rapidly.

How do you set a Silicon Atomic Projection clock?

Press down the watch’s “Receive” button with one of your fingers; the button is located in the top right corner. Hold the button down with your finger to make the watch connect to the United States atomic clock with its radio transmitter; the watch will then set itself to the appropriate time zone.

How long for atomic clock to set?

When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.

What does mer mean on atomic clock?

Modulation error ratio – Wikipedia.

Why hasn’t my atomic clock changed time?

If your clock did not change with Daylight Savings Time (DST), make sure the DST switch on the back of the clock is set to ON. If your clock is off by increments of an hour, the Time Zone (TZ) is set incorrectly. Check the Time Zone switch on the back of the clock. If the problem persists, we have a one year warranty.

THIS IS INTERESTING:  Why is my Apple Watch zoomed in?

How do you know if you’re Pacific or Eastern?

The Eastern Time zone covers all or part of 22 states from Maine down to Florida, including some Midwestern states. The Pacific Time zone covers all or part of five states from Washington to California.

How do I reset my Silicon scientific Atomic Projection Clock?

To reset the unit, press the reset button typically located on the back of the clock or in the battery compartment. This may require a paper clip.

How do I reset my atomic clock?

Press and hold the “REC” button (D) for 3 seconds. The clock will search for the atomic signal. The clockʼs hands will move to the 12:00 position and the atomic signal will be received within 3-12 minutes. Once the atomic signal has been received, the clock will set itself to the correct time.