How do I get past Apple watch basics screen?
Answer: A: It looks like the watch has reloaded software and is stuck in the initial first-power-up guide. Try a forced reset by pressing and holding both buttons (about 10 seconds) until the Apple logo appears, then let it reboot.
How do I set up Apple watch after Apple watch Basic?
Set up your Apple Watch
- Turn on your Apple Watch and put it on. …
- Hold your Apple Watch close to your iPhone. …
- Hold your iPhone over the animation. …
- Set up as new or restore from a backup. …
- Sign in with your Apple ID. …
- Choose your settings. …
- Create a passcode. …
- Choose features and apps.
How long does Apple watch basics take?
Even a full charge from a very low battery level will only take up to around 2.5 hours. It should not take too long to pair the watch. Perhaps allow an hour or so to pair and sync your watch and to explore and configure some of the settings to your preferences.
How do you hard reset an Apple Watch?
How to Hard Reset Apple Watch
- Hold down the side button and Digital Crown at the same time. The Digital Crown is the rotating button located on the side of the device.
- Keep holding these two buttons down until you see the Apple logo appear on the screen.
Why does my Apple Watch just have the Apple logo on it?
It could be that you have accidentally entered Screen Curtain accessibility mode. To exit this mode and hopefully get rid of the logo, open the Apple Watch app on your iPhone. Hit General, then Accessibility. Go to Voice Over, and switch off both Voice Over and Screen Curtain.
How do I set up my Apple Watch without my iPhone?
Without being paired to your iPhone, there are even more ways you can use your Apple Watch when connected to a Wi-Fi network. Just as you would on an iPhone, you can connect to a Wi-Fi network under the settings icon on the watch. You can type in Wi-Fi network passwords with the Scribble feature.
How do I disconnect my Apple Watch?
How to unpair an Apple Watch via the Watch app
- Go to the Apple Watch app on your iPhone.
- Tap All Watches at the top of the My Watch screen.
- Tap the info button to the right of your current watch.
- Select Unpair Apple Watch.
- Confirm the process by pressing Unpair (watch name).
How do I turn off the double tap on my Apple Watch?
Open the Settings app on your Apple Watch. Go to Accessibility > VoiceOver, then turn on VoiceOver. To turn VoiceOver off, double-tap the VoiceOver button.
What do I do if my Apple Watch won’t unlock?
Press and hold the side button until you see Power Off. Press and hold the Digital Crown until you see Erase all content and settings. Tap Reset, then tap Reset again to confirm. Wait for the process to finish, then set up your Apple Watch again.
How do you unlock an Apple Watch?
You can unlock Apple Watch manually, by entering the passcode, or set it to unlock automatically when you unlock your iPhone. Enter the passcode: Wake Apple Watch, enter the watch passcode, then tap OK.
How long does it take to unpair an Apple Watch?
Then you’ll get a prompt asking for your Apple ID password to be able to continue. From here, your Apple Watch and iPhone will start to disconnect and this may take up to 10 minutes or so depending on how much data you have on your wristwear.
Do you need Wi-Fi to sync Apple Watch?
To enjoy every feature on your Apple Watch, you need to turn on Wi-Fi and Bluetooth on your paired iPhone. … Your Apple Watch uses Wi-Fi and Bluetooth to communicate with your paired iPhone. If you have cellular, your watch can also stay connected through a cellular network.
What does it mean turn digital crown to unlock and eject water?
It is found in Apple Series 2-6. The feature locks the screen to prevent the user from activating it while swimming. It can also be used to deter long-term problems by eliminating trapped moisture. This article is going to discuss methods about how to turn Digital Crown to unlock and eject water on Apple Watch.