Do not be nervous to “over-wind” your clock. Contrary to the eternal “over-winding” myths, it is not possible to over-wind your clock’s mainspring. With practice, you will become accustomed to how many turns of the key are required for a full winding.
What happens to an overwound clock?
Specifically, if a clock is wound fully, eventually the winding key will no longer turn. … When the condition of a clock is described as “overwound,” there is always another underlying cause for why the clock will not run. The clock ends up fully wound because winding is the first thing we try when a clock has stopped.
How do you unwind an overwound mantle clock?
Turn the key slowly and just a half turn at a time. Wind it up until it stops. Do not try to force it to wind any further. Even though it is impossible to over-wind your clock, it is also not necessary to wind it until the last possible click of the ratchet.
How often should you wind a mantel clock?
Clocks with two and three gear sets will be able to chime on the hour and quarter hour respectively. Additionally, most clocks are set to run for eight days, before having to be wound. It’s always a good idea to wind them every seven days. By winding every seven days you prevent the clock from stopping.
Why does my mantel clock keep stopping?
A clock that is out of beat is likely to stop because the pendulum is not receiving the optimum impulses to keep it swinging. … For mantle clocks with a pendulum, a temporary cure may be to place something under one side of the clock, such as a coin, and listen again to see if it’s any better.
Can an overwound clock be fixed?
Solutions to overwound clocks
Begin by removing the outer shell of the clock, exposing the mechanism. … You can also apply small amounts of clock cleaning fluid, which should be available to find online with a bristle brush if required, however most find that warm water may tackle the job just as well.
Is it OK to turn a clock backwards?
If your timepiece has a mechanical movement, then it is best not to put the clock in reverse. If your timepiece is a quartz movement, you are probably safe to turn it backward. If you have a very old cuckoo clock, it may not even go in reverse without breaking the mechanism.
How do you fix a grandfather clock that is wound to tight?
Strike weight stuck
With some cloth gloves on, or at least a cloth of some kind, pull down on the weight some. Again, this is the same as making the weight weigh more. Doing this will make the clock strike. Advance the minute hand and let it chime each quarter until it plays the top of the hour song.
What are the two winding holes on a clock?
The middle hole will wind the spring that powers the timekeeping function of the clock. The right hole, as you’re looking at the clock, powers the chimes of the clock. Finally, the left winding hole, as you’re looking at the clock, powers the hourly strikes of the clock.
How often do you wind a Howard Miller mantel clock?
Howard Miller clocks have one to three winding holes. Turn the key clockwise until tight. Wind the clock once a week.
How do you wind an 8 day clock?
Winding – Eight Day clock:
Turn the key with a smooth motion, stopping when the spring will not wind any further. Never let the key snap back in your hand, always release it gently after each half turn. Make sure the clock is fully wound, so keep turning the key until the spring will not wind any further.